Solicité el puesto en persona. El proceso duró 3 semanas. Acudí a una entrevista en GE (Erie, PA) en ago 2010
Entrevista
Most interviewees are selected from an internal pool of Early Identification (EID) candidates; these are mostly interns and co-op students. The interview process consisted of four 30-45 minute interviews with senior engineering technical leaders/managers.
Preguntas de entrevista [1]
Pregunta 1
How my time with the company thus far (during internship) had an impact on the company and why should they hire me.
Solicité el puesto a través de la escuela superior o la universidad. El proceso duró 2 días. Acudí a una entrevista en GE (Tiruchchirāppalli) en ago 2018
Entrevista
Written that includes Tech and apti reasoning english.
and in interview they are asking about design subjects..if your project will be in additive manufacturing then prepare well because they asked good questions.
Solicité el puesto a través de la escuela superior o la universidad. El proceso duró 1 semana. Acudí a una entrevista en GE (Warangal) en sept 2017
Entrevista
1st round was written in which aptitude, English and technical knowledge of field was asked since i am from mechanical field so they asked few questions covering all the subject though i am mtech thermal engg student but they asked about btech mechanical question
Preguntas de entrevista [1]
Pregunta 1
about my current project?
stress strain curve
gas turbine cycle pv diagram
Envié una solicitud electrónica. Acudí a una entrevista en GE (Tiruchchirāppalli) en ago 2017
Entrevista
There was an online test followed by technical and hr interview. The online test consisted of three sections namely aptitude, verbal ability and english. The interview willl be based on areas of interest that you choose and your project and internship.
Preguntas de entrevista [1]
Pregunta 1
They asked from my area of interest like thermodynamics and power plant engineering.