Solicité el puesto a través de la escuela superior o la universidad. El proceso duró 1 día. Acudí a una entrevista en Texas Instruments (Vāranāsi) en dic 2015
Entrevista
it was four round process ,1st one was written after that 2 technical round and 1 hr round.
in written there was to round technical portion contained basics from opamp, diode circuit , zener diode circuit....they asked output waveform for step input and sinusoidal input most of the circuit.
In technical round they asked about my project .Most of the question was based on RC circuit step response , Basics of opamp ,Fourier Series and filter analysis.
Preguntas de entrevista [1]
Pregunta 1
Read RC circuit Fourier Series ,Mos Basics ,Filters, OPamps.
Acudí a una entrevista en Texas Instruments (Bengaluru)
Entrevista
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
Acudí a una entrevista en Texas Instruments (Bangalore Rural)
Entrevista
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.
