Solicité el puesto a través de la escuela superior o la universidad. Acudí a una entrevista en Texas Instruments (Bengaluru) en sept 2015
Entrevista
TI visited our collage in September.The first round is online test which consists of two sections 1)tecnical 2)aptitude.Technical consists of basic questions which are really logical,one should be good in network theory(rc transients),analog(opamps),control systems(bode plot).After 1st round i was selected for telephonic interview,in which i was asked basic questions on rc transcients,opamps,fourier series.After that i was called for F2F interview at Banglore where i was asked questions mainly on opamps(input resistance,output resistance based questions),some digital questions based on mux,rc transients etc
Preguntas de entrevista [1]
Pregunta 1
one should be perfect in rc transients,opamps,Thevinins based questions using opamps,better to have some basic knowledge on digital
Acudí a una entrevista en Texas Instruments (Bengaluru)
Entrevista
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
Acudí a una entrevista en Texas Instruments (Bangalore Rural)
Entrevista
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.
