Solicité el puesto a través de la escuela superior o la universidad. El proceso duró 3 semanas. Acudí a una entrevista en Texas Instruments (Dallas, TX)
Entrevista
3 rounds Forst round was on campus with a recruiter and it was more to gage your interest in the company and technology that it is working on. Then there was an online aptitude test that consisted of sorting numbers and an online personality test where you pick between 2 bad choices for multiple scenarios. Then you go on to the person to person interviews both are to get to know you where they ask about you and and ways you've overcome challenges in life. The second interview will require you to to give a presentation on a project you've done.
Preguntas de entrevista [1]
Pregunta 1
Design a circuit that has a 2V input and a -10V output. Draw differentiator. Given this digital circuit with a fault here what are the inputs to the circuit needed to detect the error in 1 pass.
Acudí a una entrevista en Texas Instruments (Santa Clara, CA)
Entrevista
There was 1 behavior video call (standard), and then a few weeks later, there was 1 technical video call with 2 interviewers -- was also asked to prepare a technical presentation beforehand, then asked other EE technical questions afterward
Acudí a una entrevista en Texas Instruments (Austin, TX)
Entrevista
1 round phone interview with HR. 1 round technical with on-site recruiter after a career expo. the technical interview was 1 hour wit ha mix of technical and behavorial questions
Preguntas de entrevista [1]
Pregunta 1
Draw a non inverting op-amp. write expression for gain
Solicité el puesto a través de la escuela superior o la universidad. El proceso duró 3 semanas. Acudí a una entrevista en Texas Instruments (Dallas, TX) en oct 2024
Entrevista
Applied for a full time position which requires 2 rounds. Currently preparing for the final round interview which has been postponed twice already. I was asked to give a 15min presentation on a technical subject for the final round interview. The first round was 40% behavioral and 60% technical i would say. The questions were centered around how you would do troubleshooting of an arbitrary electrical system but every time I gave an answer they would complicate the problem a bit more and see how i would respond.
Preguntas de entrevista [1]
Pregunta 1
Give me 5 measurable characteristics of a clock signal
