Solicité el puesto a través de un captador. Acudí a una entrevista en Tesla (Hawthorne, CA)
Entrevista
starts with a phone call w recruiter for basic questions, then a technical exam on mechanical concepts, then two technical interviews over video or phone, and finally onsite interview with a panel. Asked for feedback after rejection but didn't even receive an email reply.
Preguntas de entrevista [1]
Pregunta 1
Draw moment and shear diagrams for a simply supported beam
Horrible experience. It was more of a 1 hour humiliation call than an interview. The man was asking questions non stop and would until he found an area I didn't have a lot of experience (not required or mentioned in the position) and he started asking more about that, even laughed at me.
Preguntas de entrevista [1]
Pregunta 1
Gdt
Casting
Plastic injection
Questions about elon
Solicité el puesto por otro medio. Acudí a una entrevista en Tesla
Entrevista
It was good. Mainly focus on Stress strain curve. And bending movement diagram and shear force diagram. Moment of inertia and stuff. Aluminum vs Steel, properties. Resume review and formulas
Preguntas de entrevista [1]
Pregunta 1
Explain stress strain curve and label all the points
6 round selection process. First CV screening. assignment to show your skills. first interview with HR (30 minutes). Second interview with hiring manager. third interview with senior engineer from canada. fourth interview with hiring manager from america