Envié una solicitud electrónica. El proceso duró 4 semanas. Acudí a una entrevista en Tesla (Fremont, CA) en mar 2022
Entrevista
The interview process consisted of one phone screen, followed by a 30 minute phone interview. Next, I took a mechanical engineering test that tested basic fundamentals like stress-strain curves, GD&T, etc. Finally, there was a 6 hour panel interview with many managers and engineers.
Preguntas de entrevista [1]
Pregunta 1
What is the optimal beam cross section to withstand buckling (per mass)? What is the optimal cross section to withstand bending (per mass)?
Horrible experience. It was more of a 1 hour humiliation call than an interview. The man was asking questions non stop and would until he found an area I didn't have a lot of experience (not required or mentioned in the position) and he started asking more about that, even laughed at me.
Preguntas de entrevista [1]
Pregunta 1
Gdt
Casting
Plastic injection
Questions about elon
Solicité el puesto por otro medio. Acudí a una entrevista en Tesla
Entrevista
It was good. Mainly focus on Stress strain curve. And bending movement diagram and shear force diagram. Moment of inertia and stuff. Aluminum vs Steel, properties. Resume review and formulas
Preguntas de entrevista [1]
Pregunta 1
Explain stress strain curve and label all the points
6 round selection process. First CV screening. assignment to show your skills. first interview with HR (30 minutes). Second interview with hiring manager. third interview with senior engineer from canada. fourth interview with hiring manager from america