Envié una solicitud electrónica. Acudí a una entrevista en One-Cycle Control (Irvine, CA) en sept 2025
Entrevista
Three rounds in one day:
1. Electrical equipment test (oscilloscope and multimeter)
2. Mechanical test (take apart mechanical part and put back together with screwdriver)
3. Written exam of electrical engineering fundamentals (logic gates, op amp, power)
Envié una solicitud electrónica. El proceso duró 2 semanas. Acudí a una entrevista en One-Cycle Control (Irvine, CA) en feb 2023
Entrevista
The interview process was normal but a little odd. After getting the interview, they asked me to disassemble and reassemble a small mechanical part using some tools. Once finished with that, they sent me up to the interview room where there were very few behavioral questions and instead there were mostly technical questions.
Preguntas de entrevista [1]
Pregunta 1
Why is a cantilever beam stronger when its height is longer than its width?
Envié una solicitud electrónica. El proceso duró 1 día. Acudí a una entrevista en One-Cycle Control en feb 2023
Entrevista
The interview was in person and I was interviewed by three team members. The interview lasted about three to four hours. First part was going over my resume and was followed by technical questions.