Solicité el puesto a través de la recomendación de un empleado. El proceso duró 1 día. Acudí a una entrevista en Cadence Design Systems (Bengaluru) en feb 2016
Entrevista
i had two rounds. one is written test and another one is technical interview. written test has full of analog design questions. paper was difficult for fresher. most of the questions are on mosfets and op-amps. some of the questions are on network theory(R L C circuits). In interview, questions were completely on mosfet basics, capacitor charging and discharging with constant current source and with constant voltage source, and some questions on projects.
Preguntas de entrevista [1]
Pregunta 1
Rlc circuits, mosfet small signal analysis, differential amplifiers, opamp basics.
Solicité el puesto a través de la escuela superior o la universidad. El proceso duró 2 días. Acudí a una entrevista en Cadence Design Systems (Puttūr, Karnataka) en sept 2025
Entrevista
There were questions related to RC circuits, steady state, diode circuit, Truth table of given Digital circuit, Op amp basic configuration outputs.
Concentrate mostly on RC circuits.
The first round had 20 questions and time given was 1 hour. They don't expect you to solve all the questions. They observe your working sheets.
Second round was descriptive answers round. There were questions again on RC, resistors combinations, Timing constants. It had 13 technical and 3 aptitude questions.
Total 3 technical rounds. Questions mostly based on prior projects and analog design fundamentals. RC circuits - step, impulse, ramp, pulse response, CMOS basic amplifier stages, differential amplifiers and current mirrors.
Acudí a una entrevista en Cadence Design Systems (Bengaluru)
Entrevista
Analog design related questions:
Mostly RC circuits and Opamp design related questions.
They also asked regarding my work experience and previous projects that I had worked on.
How to design an LDO, and design considerations for it?