Envié una solicitud electrónica. Acudí a una entrevista en Leap Tools en jun 2026
Entrevista
Basically the same questions as before about pagination (implement pagination at a pivot index) and symmetric 2D binary matrix (make the matrix both horizontally and vertically symmetrical using minimum row and column insertions)
The interview first started with your self-Introduction, your hobbies, and the experience of there Demo for 10 min and coding question 40 min. Overall experience is not bad, coding question was a bit tricky.
Solicité el puesto a través de una agencia de empleo. Acudí a una entrevista en Leap Tools en mar 2026
Entrevista
The process consisted of two technical coding rounds. The first round focused on implementing a pagination system with strict wrap-around and edge-case handling. The second round involved a 2D binary matrix problem requiring structural transformations (vertical and horizontal symmetry using insertions only). Both rounds emphasized attention to detail, correctness, and clear reasoning under constraints. The final interviewer indicated they were very satisfied with the performance and suggested I would likely move forward, but I later received a rejection email stating the decision was highly competitive.
Preguntas de entrevista [1]
Pregunta 1
Design and implement an algorithm to make a 2D binary matrix vertically and horizontally symmetric using only full row and column insertions.